Existing Lan Type - HP 9000 300 Series Hardware Configuration Manual

2
Each part of this line is explained below.
QUANTUM PD 420S, 1406, 0
Existing LAN Type
Unit 0
Bus address 6 (range
=
0 -7)
Select Code 14
SCSI interface
Unformatted size in Mbytes
Drive manufacturer
Note the line that reads something like:
HP98643 (LAN) at 21, THIN, 0800091595F3
or
HP98643 (LAN) at 21, AUI, 0800091595F3
If, after HP98643 (LAN) at 21" the word:
• THIN appears, ThinLAN is the type and the BNC connector must be used .
• AUI appears, A UI LAN is the type and the D-sub connector must be used.
,Write in the LAN type here:
Refer to chapter n, 'Setting the LAN Type' to learn how change the LAN
configuration jumper.
Your controller's LAN ID is the number at the end of that line. For example:
0800091595F3
Your system administrator uses that number for networking configuration.
2·4 Finding Your .Controller's Existing Configuration