Model 382: Ram Board Configurations For 8 Mbytes - HP 9000 300 Series Hardware Configuration Manual

5
Example: Upgrading 8 Mbytes to 16 Mbytes
To upgrade a Model 382 controller with 8 Mbytes (two existing 4 Mbyte RAM
boards) to 16 Mbytes with the HP A2201A 8 Mbyte RAM Board Set, you
would follow these steps:
1. The amount of RAM existing is 8 Mbytes. You would write that amount in
Table 5-2's 'Existing, Total' block as shown below:
Example Existing Memory vs. Upgraded Memory
Total RAM PAIR 0 RAM PAIR 1
Existing 8 MB
Upgraded
2. Refer to your controller's memory and determine the size of the RAM
boards already in the slots. One of these configurations in Table 5-3 will
exist:
Table 5-3.
Model 382: RAM Board Configurations for 8 Mbytes
Total
Memory
RAM PAIR 0 RAM PAIR 1
8 MBytes
[4 MB} [4 MB}
8 MBytes
[2 MB} [2 MB} [2 MB)[2 MB)
If two slots have boards, the boards are each 4 Mbytes. This condition is
used in this example.
You would write '4 MB' in Table 5-2's 'Existing' block for RAM PAIR 1
slots as shown below:
5-14 Memory Configurations