Toro 260 Series Service Manual page 60

HYDRO-GEAR TRANSAXLE
5. If the tractor is equipped with cruise control,
unplug the cruise control magnet and the reverse
plunger switch wiring plugs (Figure 120).
Figure 120
6. Unbolt the cruise control magnet bracket from the
side of the frame (Figure 121).
Figure 121
4 - 2
7. Unhook the Idler pulley spring from the torque
strap bracket (Figure 122).
MVC-137X
8. Remove the gas damper cylinder located next to
the transaxle input pulley. To remove the fastener
on the end of the cylinder, use a small blade
screwdriver and insert the blade of the screwdriver
between the back side of the fastener and the
shaft. Apply a little pressure toward the back of
the fastener and pull the damper cylinder off the
shaft (Figure 123).
MVC-138X
Figure 122
Figure 123
260 Series Tractor Service Manual
MVC-139X
MVC-140X