Toro 260 Series Service Manual page 84

GEAR DRIVE
5. Disconnect the idler assembly spring from the
bracket located on the left side of the frame next
to the transaxle input pulley. Also, loosen and
move the belt guide located on the same bracket
(Figure 192).
Figure 192
6. Loosen and move the belt guide located on the
right side of the frame next to the transaxle input
pulley (Figure 193).
Figure 193
5 - 8
7. Remove one screw and loosen the other screw on
the brake pedal safety switch. Turn the switch out
of the way when lowering the clutch/brake cross
shaft (Figure 194).
MVC-268X
8. Remove the brackets for the clutch/brake cross
shaft (Figure 195).
MVC-269X
Figure 194
Figure 195
260 Series Tractor Service Manual
MVC-270X
MVC-271X