Toro 260 Series Service Manual page 61

9. Slip the belt off the engine drive pulley and move
the belt slack toward the rear of the transaxle and
remove the belt around the transaxle input pulley
(Figure 124).
Figure 124
10. Use a floor jack and put it under the transaxle to
help lower the transaxle from the frame of the
tractor (Figure 125).
Figure 125
260 Series Tractor Service Manual
HYDRO-GEAR TRANSAXLE
11. Remove the front torque strap, nut, and washer
(Figure 126).
12. Remove the two nuts and washers that are
MVC-141X
located on each side of the transaxle axle housing
holding the transaxle to the frame (Figure 127).
MVC-155X
Figure 126
Figure 127
MVC-142X
MVC-146X
4 - 3