GEAR DRIVE
13. There is a belt guide located in the mid-section of
the tractor. Make sure the belt gets routed
through the wire guide (Figure 200).
Figure 200
14. Install the cotter pin and washer for the shift lever
rod (Figure 201).
Figure 201
5 - 10
15. Reinstall the clutch/brake cross shaft and tighten
the brackets (Figure 202).
MVC-277X
16. Install the screw to the safety switch and make
sure the switch is adjusted in the closed position
(Figure 203).
MVC-273X
17. Install the belt around the transaxle input pulley.
Figure 202
Figure 203
260 Series Tractor Service Manual
MVC-271X
MVC-270X