Advertisement
Suggestion:For the newly installed machine, check its level once every week.
When the foundation is rigid enough, then you may level the
machine once per month.
3.8 ELECTRICAL EQUIPMENTS
3.8.1 Electric Cabinet
The main power cable can be put into the cabinet through the bottom of the
cabinet, the main switch is located on the right side of the cabinet and
electrical diagram can be inside the cabinet.
3.8.2 Power Line
1. Make sure the voltage of incoming power supply is right type that
the machine requires or as marked on the unit.
2.Power wires, ground and over voltage protector should comply with
the local electricity regulations.
3.For wiring to other voltages, be sure to rewire the spindle motor,
coolant system and transformer to correct voltage, the relevant
currents, fuse and overload relays are shown in the electrical
manual, see Note 2.
Note:1. Do not turn on the machine motor when its voltage is different
from power voltage and contact electric technician for
reparation.
2. The spindle drive is 220 volts only and must be replaced for
other voltages.
-30-
Advertisement
