Advertisement
4.2 MACHINE OPERATION
START MACHINE PROCEDURE
1. Power On
2. Press "ON" switch from control panel
3. Check if the monitor fl ashed
4. Release "EMERGENCY" stop from control panel
5. Press " CLEAR" button from control panel
CLOSE MACHINE PROCEDURE
1. Press "EMERGENCY" stop from control panel
2. Turn "OFF" from control panel
3. Power OFF
The spindle speed of this machine is 20 r.p.m. while safety door is opened under
manual mode.
The safety door can not open unless change workpiece or manual
operation condition.
HOW TO USE DOOR INTERLOCK FUNCTION
To protect operator while machine is operated, the door can not open to
avoid workpiece injury operator.
The operator clamp workpiece into chuck fi rst, then close door next,
press "CYCLE START" button from control panel.
How to close safety door: Press "02"pad from key board, the monitor will
How to open safety door: Stop machine fi rst, then press"02"from
shows "door is lock or not"
keyboard, the safety door can be opened.
-48-
Advertisement
