Advertisement
Carve Mode and Screen
Carve mode is identified by this icon:
Carve mode can only be set in thrust, not pullback.
Accessing the Carve Screen
Push the carve button on the joystick
screen.
Push button 4 to switch between cruise and carve modes.
Activating Carve
1.
Position the drill bit in the direction (clock position) that you need to steer/carve.
2.
Return the joysticks to the neutral position.
3.
Access the carve screen using the display.
4.
Push button 2 to select the sweep angle. Use buttons 6 and 7 to adjust the level.
5.
Set the rotation speed, rotary torque, and thrust force using the carve screen on the display.
6.
Push the carve button on the joystick
Note:
The drill string should start to rotate back and forth.
7.
Push button 8 to access the thrust setting.
Note:
The icon turns green and a green circle highlights the option you select
8.
Push button 6 to slowly increase the thrust rate to the desired setting.
9.
Push button 6 or 7 to increase or decrease the value of the selected setting.
(Figure
12) or push button 4 on the home screen to access the carve
Figure 12
(Figure
12).
Figure 13
6
(Figure
13).
g298903
g291902
Advertisement
