Advertisement
The following table describes the function values affected when another function is given priority.
The priority is the function with the highest value, not the value selected in the screen.
All values are dependent on the available engine horse power.
Button
Priority
Pipe rotation speed
1
(Rotary RPM)
2
Sweep angle
3
Rotary torque
Thrust force (Carriage
5
thrust)
Thrust rate (Carriage
8
Rate/Speed)
Push the X button to return to the
Deactivating Carve
Push the carve button to deactivate the carve mode or push the joystick as follows:
•
Mode I: the right joystick in any direction
•
Mode II: the right or left joystick in forward or reverse.
Note:
The settings reset when the key is turned off or when you switch to cruise mode.
Resuming Carve
Push the carve button on the joystick to resume the functions with the same settings.
Note:
The settings reset when the key is turned off or when you switch to cruise mode.
Icon
Description
The set rotary RPM is maintained unless the set rotary torque is
exceeded, then the rotary rpm is reduced.
When not drilling: change the arc angle degree. The arc angle
will increase or decrease by 18°.
When actively drilling: change the center of the pipe rotation.
Button 6 is clockwise. Button 7 is counter clockwise. The pipe
adjusts by 18° clockwise or counterclockwise for each button press.
The set rotary torque value is maintained unless the maximum set
rotary RPM is exceeded, then the toque value is reduced.
The set carriage thrust is maintained unless the carriage rate (speed)
is exceeded, then the thrust force is reduced.
The set carriage rate (speed) is maintained unless the maximum set
carriage thrust is exceeded, then the speed is reduced.
Main Information Screen (page
7
2).
Advertisement
