Advertisement
SmartTouch™ Home
Screen
SmartTouch mode allows the operator to load and
unload pipes from the pipe box with less joystick
operation to reduce operator fatigue.
Use the
Carriage Settings Screen (page 17)
SmartTouch mode on and off.
Note:
The Push/Pull Icon has a green background
when SmartTouch mode is on and a ribbon appears
at the bottom of the screen showing a sequence of
the steps.
Important:
Never switch between Push/Pull
modes during the chosen operation. Use neutral
(manual) mode to switch between Push/Pull; refer
to
Carriage Settings Screen (page 17)
SmartTouch mode off.
Pulling Pipe in SmartTouch Mode
Start the SmartTouch mode with the cam assembly
in the park position.
Figure 14
1. Go to the previous step
1.
Push button 1 to select the pull pipe option
(Figure
15).
2.
Push buttons 2 and 3 to select the row where
you want to place the pipe
to turn
to turn
g236957
2. Go to the next step
(Figure
15).
1. Pull pipe
3.
Hold the lower right button on the left joystick
(Figure
14) until the display moves to box 2
(Figure
16) and the elevator lowers, the cam
assembly rotates toward the operator station,
and the arms fully extend
8
Figure 15
2. Select pipe row
(Figure
17).
Figure 16
g238157
g236958
Advertisement
