Mitsubishi Electric KD Series User Manual page 32

2-6 Specification
Output Mode-2
・ Refer to p34-36 for Connector assignment of Camera Link® D1-D12
・ Image data is outputted by adjacent format only. (Other image data format is not available.)
・ Refer to next page to check relationship between connector and output channel.
［1ch Output］
•KD6R1064/1247DXL-NL：
Image data is outputted from 4 connectors (D1,D2,D5,D6) if using Medium, Full, Deca Config.
Image data is outputted from 2 connectors(D1,D5) if using Base Config.
D1,D2,D5,D6 connectors belong to "Ch1".
•KD6R1688DXL-NL：
Image data is outputted from 6 connectors (D1,D2,D5,D6,D9,D10) if using Medium, Full, Deca Config.
Image data is outputted from 3 connectors(D1,D5,D9) if using Base Config.
D1,D2,D5,D6,D9,D10 connectors belong to "Ch1".
Hereinafter above output method is called "1ch output". This method is the standard output mode in ordinary operation and ex-factory
condition.
［2ch Output］
•KD6R1064/1247DXL-NL：
Image data is outputted from 8 connectors (D1-D8) if using Medium, Full, Deca Config.
Image data is outputted from 4 connectors(D1,D3,D5,D7) if using Base Config.
The connectors belonged to Ch1 and Ch2 are used in this output mode.
•KD6R1688DXL-NL：
Image data is outputted from 12 connectors (D1-D12) if using Medium, Full, Deca Config.
Image data is outputted from 6 connectors(D1,D3,D5,D7,D9,D11) if using Base Config.
The connectors belonged to Ch1 and Ch2 are used in this output mode.
Hereinafter above output method is called "2ch output".
TM-XJ959A Camera Link® is a trade mark registered by AIA（Automated Imaging Association). 32
© Mitsubishi Electric Corporation