Setting⑭: Line Adjustment - Mitsubishi Electric KD Series User Manual

5-2 Setting⑭: Line Adjustment
Address Register name
LineAdjustment
70C0h
Enable
70C4h LineAdjustmentDirection R/W
70C8h LineAdjustmentRatio
70CCh LineAdjustmentOfset
5-2-16 Line adjustment
42.3um(600dpi)
42.3um
(600dpi)
Each line of RGB photo-diodes on Sensor IC is
assembled based on 600 dpi as described above.
Line adjustment function creates internal line delay by
using embedded line memory and adjust each line data
position. (at initial setting)
TM-XJ959A
R/W Parameter
Data
Set Line adjustment On/Off
R/W 0 or 1
0:OFF /1:ON
Set transportation direction
0: Normal (B → G → R ：B-line first)
0 or 1
1: Opposit (R → G → B ：R-line first)
Resolution in transportation direction／600dpi Ratio
R/W 1 to 16384 (0.03 to 4.0)
LineAdjustmentRatio =
Offset setting of Green pixel (0 to 1.0)
R/W 0 to 4096
Transport
direction
Function
Resolution(transportation direction)/600dpi×4096
ܴ݁݃݅ ‫݁ݑ ݈ܽݒ ݎ݁ ݐݏ‬
ܱ݂݂‫= ݐ݁ݏ‬
4096
[Function]
This function adjusts the different position of each RGB
line into a certain position that scans same area of object.
Set the value of LineAdjustmentRatio according to the ratio
of the resolution in transportation direction.
Example:Reslution in transportation direction 300dpi
LineAdjustmentRatio =300dpi/600dpi×4096=2048
[Remark]
1) An unstable transportation speed may cause a color
bleeding or blurring.
2)This function is not to completely control a color bleeding
or blurring. Use the effect of this function after confirmation
enough.
3)When you organize Line adjustment by your system, use
this product as Line adjustment OFF.
4)For more details, please refer to Function Specification.
Initial
1
0
4096
0
81
© Mitsubishi Electric Corporation