Setting⑲: Output Width Setting - Mitsubishi Electric KD Series User Manual

5-2 Setting⑲: Output Width Setting
Address Register name
6034h Width_1
6038h Width_2
603Ch Width_3
5-2-21 Output width setting
[Function]
Setting output resolution of main scanning direction from
CIS.
The value of Width is defined number of the output pixels
in 1ch output.
Number of the output pixels of each ch in 2ch output is
depended on overlap setting and as follows.
Overlap "disable" : Number of the output pixels = Width/2.
Overlap "Enable" : Number of the output pixels
= Width/2 ＋A/2.
* A = The addition pixels by the overlap
144pixels@600dpi, 72pixels@300dpi,
48pixels＠200dpi, 36pixels＠150dpi
*Position of the output pixel:
Ch1 = 1 to Width/2＋A/2
Ch2 = Width/2-A/2+1 to Width
TM-XJ959A
R/W Parameter
Data
Setting output resolution of main scanning direction output from
R/W 0 to 16380 Camera Link® connector(D1～D4)
(L4/L5/L6 commonly use）
Setting output resolution of main scanning direction from
R/W 0 to 16380 Camera Link® connector(D5～D8)
(L4/L5/L6 commonly use）
Setting output resolution of main scanning direction output from
R/W 0 to 16380 Camera Link® connector(D9～D12)
(for L6 use only）
Function
【Remark】
1) When you select lower resolution and operate high-speed
line rate, this register values need to be changed from initial
settings.
2) The value of "Width" has to be greater than the actual
number of output pixel.
The minimum of Width changes by resolution setting,
interpolation setting, overlap setting. Refer to Appendix
E(1) for the minimum of Width every each setting.
When a value of Width is bigger than the number of the
pixels that CIS really outputs, the data of
the dummy pixel are output at the end.
*There are no 600dpi, pixel interpolation, and the initial
value of Width of each model sets the value that
supported without overlap.
3) Please set an even number when the output pixels is set at
the 2ch setting.(The setting with the odd number is possible,
but works an even number in the CIS inside)
Camera Link® is a trade mark registered by AIA（Automated Imaging Association).
Initial
L4:12096
L5:13824
L6:13824
L4:12960
L5:15552
L6:12960
L6:12960
86
© Mitsubishi Electric Corporation