Table of Contents
Advertisement
4
BODY AND TRIM
Forward/Reverse Switch Removal, Continued:
Figure 4-16 Electric Forward/Reverse Switch
2. Remove four screws and nylon lock nuts securing the Forward/Reverse shifter to the rear body.
3. Remove the shifter lever screw, lever and wave washer.
4. Remove the shifter cable from the cable hanger under the driver-side seat hinge.
5. Pull the Forward/Reverse shifter (with wiring and cable assembly still connected) from back surface of
body and allow it to rest on engine or frame.
6. Gasoline vehicles:
6.1. Remove two nylon lock nuts from fuel pump and remove fuel pump from back of kick panel, and
allow it to rest on engine or frame.
7. Remove Forward/Reverse switch shifter.
Forward/Reverse Switch Installation
1. Position Forward/Reverse switch shifter on back of the body at hole locations.
2. Install screws and lock nuts to Forward/Reverse switch or shifter to 33 in-lb (2.8 N·m).
2.1. Gasoline vehicles: Install Forward/Reverse handle and wave washer and tighten to 14 in-lb (1.6
N·m).
2.2. Check the choke push rod for position and adjust if necessary.
2.3. Route shifter cable up into driver side corner of body on onto cable hook.
2.4. Install fuel pump onto frame support and tighten hardware to 38 in-lb (4.3 N·m).
2.5. Connect the battery cables, positive (+) cable first, and tighten terminals to 12 ft-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
2.6. Electric vehicles: Connect the four-pin connector (12) and the three-pin connector (13) to the For-
ward/Reverse switch.
2.7. Connect the battery cables, positive (+) cable first, and tighten terminals to 110 in-lb (12.4 N·m).
Coat terminals with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
Page 4-12
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
12
13
Rear Body and Fenders
Advertisement
Table of Contents
