Husqvarna HUV4210 2005 Series Maintenance Service Manual page 59

ACCELERATOR AND BRAKE PEDAL GROUP
Figure 5-27 Brake Rod Adjustment
5. Adjust accelerator pedal height.
5.1. Loosen the nut and bolt (Figure 5-28, Page 5-19) securing the accelerator pedal to the pivot plate.
5.2. Clamp the accelerator pedal adjustment tool (Husqvarna 603 00 18-32) to the accelerator pedal,
with the end marked accelerator pedal height closest to the floorboard (Figure 5-29, Page 5-19).
Press the accelerator pedal until the end of the tool rests against the floorboard; pedal height
should be 5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in position against the floorboard
and then tighten nut to 26 ft-lb (35.3 N·m).
6. Adjust the brakes. See Brake Adjustment, Section 6, Page 6-8.
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
ACCELERATOR PEDAL
ADJUSTMENT TOOL
(CCI P/N 101871001)
Figure 5-29 Accelerator Pedal Height Adjustment
Pedal Group Adjustment – Electric Vehicles
Figure 5-28 Accelerator Pedal Height Adjustment
RUBBER STRAP
5
Page 5-19