Husqvarna HUV4210 2005 Series Maintenance Service Manual page 40

4
BODY AND TRIM
Rear Body Installation, Continued:
5. Driver side rear fender:
NOTE: If only the driver side fender has been removed, use the following procedure for installation
5.1. Install fender in reverse order of removal.
5.2. Tighten side bolts to 25 in-lb (2.8 N·m).
5.3. Tighten top bolt to 25 in-lb (2.8 N·m).
FLOOR MAT
See General Warning, Section 1, Page 1-1.
FLOOR MAT REMOVAL
1. Remove the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.
2. Slide the mat from under the edge of the rear body. Loosen the rear body screws if necessary.
3. Slide the mat away from the trim up under the dash and remove the floor matt.
FLOOR MAT INSTALLATION
1. Reverse the removal procedure to install the floormat. If loosened, tighten rear body screws to 48 in-lb
(5.4 N·m).
2. Install the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.
Page 4-14 2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
Floor Mat