Table of Contents
Advertisement
5
ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group Adjustment – Gasoline Vehicle, Continued:
Figure 5-16 Brake Rod Adjustment
5. Adjust accelerator pedal height.
5.1. Loosen the nut and bolt (Figure 5-17, Page 5-14) securing the accelerator pedal to the pivot plate.
5.2. Clamp the accelerator pedal adjustment tool (Husqvarna 603 00 18-32) to the accelerator pedal,
with the end marked accelerator pedal height closest to the floorboard (Figure 5-18, Page 5-14).
Press the accelerator pedal until the end of the tool rests against the floorboard; (pedal height
should be 5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in position against the floorboard
and then tighten nut to 26 ft-lb (35.3 N·m).
6. Adjust the accelerator rod. See following DANGER.
ý
DANGER
• Before servicing, turn the key switch to OFF and place the Forward/Reverse handle in the
NEUTRAL position.
• To prevent accidentally starting the vehicle, disconnect the battery as instructed in WARNING
"To avoid unintentionally starting..." in General Warning, Section 1, Page 1-1. This will prevent
the possibility of the vehicle running over you when you are adjusting the accelerator rod.
6.1. Remove the electrical box screw and cover. See preceding DANGER.
Page 5-14
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
ACCELERATOR PEDAL
ADJUSTMENT TOOL
(CCI P/N 101871001)
Figure 5-18 Accelerator Pedal Height Adjustment
Pedal Group Adjustment – Gasoline Vehicle
Figure 5-17 Accelerator Pedal Height Adjustment
RUBBER STRAP
Advertisement
Table of Contents
