Table of Contents
Advertisement
BODY AND TRIM
TOUCH-UP PAINT COLOR CHART
COLOR
Husqvarna Orange
FRONT BODY
See General Warning, Section 1, Page 1-1.
BUMPER REMOVAL
1. Remove bolts (3) and (5) and lock nuts (4) and pull bumper (1) from vehicle frame (Figure 4-1,
Page 4-3). See following WARNING.
ý
WARNING
• Have another person hold bumper firmly against the frame when removing the last bolt. The
bumper weighs approximately 40 pounds. Hold the bumper securely during removal to avoid
personal injury.
BUMPER INSTALLATION
1. Position bumper against body and front frame and loosely install top bolts and lock nuts. See following
WARNING.
ý
WARNING
• Have another person hold bumper firmly when installing first bolt. The bumper weighs
approximately 40 pounds. Hold the bumper securely during installation to avoid personal
injury.
2. Install bottom bolts and lock nuts. Tighten hardware to 17.5 ft-lb (24 N·m).
3. Tighten top hardware to X17.5 ft-lb (24 N·m).
1
3
5
TYPICAL
4 PLACES
Figure 4-1 Front Bumper
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
HUSQVARNA P/N
Husqvarna 603 00 33-29
TYPICAL
4 PLACES
2
3
5
TYPICAL
TYPICAL
4 PLACES
4 PLACES
Figure 4-2 Front Brush Guard
4
Front Body
Page 4-3
Advertisement
Table of Contents
