Restoring Factory Settings - Siemens SINAMICS S120 Getting Started

A.2

Restoring factory settings

In rare cases, it may be necessary to revert the target device (the training case) back to
factory settings. The simulated drive in the training case thus obtains a defined state once
again and you can then restart the configuration on a secure basis. Factory settings can only
be reached in online mode.
Procedure
1. Go to the menu items "Project > Connect to selected target devices" to switch to online
2. Activate the "DEVICE" option.
Getting Started
Getting Started, 01/2013, 6SL3097-4AG00-0BP2
mode.
The window "Target Device Selection" opens and lists the configured drive units.
Figure A-1 Access point control
Appendix
A.2 Restoring factory settings
45