Autonomous Single-Axis Operations - Siemens SINUMERIK 840D sl Function Manual

Value
0
1
The desired interpolation response in G0 can also be programmed via the two following part
program commands, independently of the default:
RTLIOF
RTLION
The currently set interpolation response of the path axes with G0 can be queried with system
variable $AA_G0MODE.
Note
In both interpolation types, rapid override is channel-specific.
11.3.3

Autonomous single-axis operations

Functionality
Single PLC axes, command axes started via static synchronized actions or asynchronous
reciprocating axes can be interpolated independently of the NCK. An axis/spindle
interpolated by the main run then reacts independently of the NC program with respect to:
● NC STOP
● Alarm handling
● Program control
● End of program
● RESET
Marginal conditions
Axes/spindles currently operating according to the NC program are not controlled by the PLC.
Command axis movements cannot be started via non-modal or modal synchronized actions
for PLC-controlled axes/spindles. Alarm 20143 is signaled.
Extended Functions
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Description
In the rapid traversing mode (G0) the non-linear interpolation is active.
Path axes are traversed as positioning axes.
In the rapid traversing mode (G0) the linear interpolation is active.
The path axes are interpolated together.
Deactivating the linear interpolation.
⇒ In the rapid traversing mode (G0), the non-linear interpolation is active.
Activating the linear interpolation.
⇒ In the rapid traversing mode (G0), the linear interpolation is active.
11.3 Motion behavior and interpolation functions
P2: Positioning axes
773