Restrictions - Siemens SINUMERIK 840D sl Function Manual

MOV command
MOV = 1
MOV = 0
DELDTG command
In the case of indexing axes without Hirth tooth system:
In the case of indexing axes with Hirth tooth system:
16.5.4

Restrictions

Transformations
The axis for which the Hirth tooth system is defined cannot take part in kinematic
transformations.
PRESET
The axis for which the Hirth tooth system is defined cannot be set to a new value with
PRESET.
Rev. feedrate
The axis for which the Hirth tooth system is defined cannot be traversed at revolutional
feedrate.
Path/velocity overlay
The axis for which the Hirth tooth system is defined cannot be used with path or velocity
overlay.
Frames, ext. work offset, DRF
The axis for which the Hirth tooth system is defined does not support frames or interpolation
compensation such as external work offsets, DRF, etc.
Extended Functions
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Works on indexing axes with and without Hirth tooth system.
Same function for both: approaches the next position.
T1: Indexing axes
16.5 Equidistant index intervals
Axis stops immediately.
Axis traverses to next position.
957