Smart Line Modules (5 Kw And 10 Kw) With Cold Plate; Description; Safety Information - Siemens SINAMICS S120 Equipment Manual

Smart Line Modules (5 kW and 10 kW) with cold plate

7.1

Description

The Smart Line Module is an unregulated infeed/regenerative feedback unit. The Smart Line
Module supplies the Motor Module(s) with an unregulated DC voltage at the DC output. In
the infeed mode the Smart Line Module exhibits the typical current and voltage waveforms of
a 6-pulse diode rectifier bridge.
In feedback mode, the current waveform is square waved. Feedback can be deactivated by
means of a terminal because these Smart Lines Modules are not equipped with a DRIVE-
CLiQ connection.
The DC link starts precharging as soon as the supply voltage is applied and is independent
of its phase sequence direction. Load can be applied to the DC link after the modules have
been enabled. An optional main contactor is required for disconnecting the voltage.
Smart Line Modules are suitable for direct operation in TN, IT, and TT systems. The Line
Modules have an integrated overvoltage protection function.
7.2

Safety Information

Risk of electric shock. A hazardous voltage is present for up to 5 minutes after the power
supply has been disconnected.
The protective cover may only be opened after this time has expired.
When opening the protective cover for the DC link, you must activate the release. A
suitable tool (e.g. screwdriver) must be used for this purpose.
The components must only be operated when the protective cover of the DC link is closed.
Damaged components must not be further used otherwise this could result in secondary
damage or accidents.
Booksize cold-plate power units
Manual, (GH4), 03.2007, 6SL3097-2AJ00-0BP4
DANGER
WARNING
7
161