Before First Use - Silvercrest SKMK 1000 A1 Operating Instructions Manual

Before first use

WARNING
► Hot steam escapes from the steam outlet openings 2 of the appliance lid!
There is a risk of scalding!
► Never open the appliance lid while brewing is in progress! Bursts of hot
steam may be released or hot water may spray out. There is a risk of
scalding!
► The hotplate 7 under the coffee pot 6 is heated strongly during the
brewing/keeping warm process. There is a risk of burns!
CAUTION – PROPERTY DAMAGE!
► Never fill the water tank 0 to more than the total amount required for
10 cups (MAX marking).
► There is a small hole 3 on the back of the appliance. This is a water over-
flow that prevents too much water from being poured into the appliance. If
the water level exceeds the MAX mark, the water will escape through the
water overflow 3 onto the worktop.
► If the appliance is moved with a full water tank 0 (10 cups of water),
water may run out through the water overflow 3.
► Never fill the water tank 0 with less than 2 cups of water. Use the fill level
indicator 4 on the water tank 0 for reference.
1) Place the appliance on a level and heat-resistant surface.
2) Rinse the coffee pot 6 thoroughly with water and place it in the appliance.
3) Open the appliance lid by pulling it upwards by the handle 1.
4) Remove the filter basket q from the filter basket holder 9.
5) Rinse the filter basket q in fresh water and replace it in the appliance.
6) Fill the water tank 0 with water for 10 cups.
7) Close the appliance lid.
8) Insert the plug into a mains power socket.
9) Press the
The brewing process begins.
10) Wait until the brewing process is completed and press the
again to turn off the appliance.
SKMK 1000 A1
button 5. Wait a moment. The button 5 lights up.
button 5
GB │ IE │ NI │ CY │ 7 ■