Starting The Brewing Process - Silvercrest SKMK 1000 A1 Operating Instructions Manual

CAUTION
Property damage!
► Never fill the water tank 0 to more than the total amount required for 10
cups (MAX marking).
► There is a small hole 3 on the back of the appliance. This is a water over-
flow that prevents too much water from being poured into the appliance.
If the water level exceeds the MAX mark, the water will escape through the
water overflow 3 onto the worktop.
► If the appliance is moved with a full water tank 0 (10 cups of water),
water may run out through the water overflow 3.
► Never fill the water tank 0 with less than 2 cups of water.
NOTE
► During the brewing process, the amount of water decreases: some evapo-
rates and the coffee grounds also retain some water. Therefore, there will
always be a little less coffee in the coffee pot 6 than the amount of water
you have poured into the water tank 0.

Starting the brewing process

WARNING
► Hot steam escapes from the steam outlet openings 2 of the appliance lid!
There is a risk of scalding!
► Never open the appliance lid while brewing is in progress! Bursts of hot
steam may be released or hot water may spray out. There is a risk of
scalding!
► The hotplate 7 under the coffee pot 6 is heated strongly during the
brewing/keeping warm process. There is a risk of burns!
1) Press the
The brewing process begins.
NOTES
► You can briefly remove the coffee pot 6 from the appliance during the
brewing process, for example to pour a cup of coffee. The brewing stops
automatically and the coffee no longer drips out of the machine. However,
place the coffee pot 6 back on the hotplate 7 after 10 seconds at the
latest, otherwise coffee may drip out of the machine.
► You can stop the brewing process at any time by pressing the
SKMK 1000 A1
button 5. Wait a moment. The button 5 lights up.
button 5.
GB │ IE │ NI │ CY │ 9 ■