Technical Specifications; What This Chapter Contains - ABB PQFS Installation, Operation And Maintenance Instructions

—

12 Technical specifications

12.1 What this chapter contains

This chapter contains the technical specifications of the active filter PQFS.
12.2 Technical specifications
The PQFS is an active filter for three phase networks with or without neutral for filtering
of non-zero sequence harmonics and reactive power compensation including balancing
between phases.
Installation location
Indoor installation on firm foundation in a clean environment
Altitude
Minimum temperature
Maximum temperature
Recommended maximum average
temperature (over 24 h)
Relative humidity
Contamination levels (IEC 60721-3-3)
Vibration (IEC 60068-2-6)
Shock (IEC 60068-2-27)
Filter installation information
Degree of protection
Dimensions per power unit enclosure
(appr.)
Weight per power unit enclosure
(unpacked)
Color
Mechanical installation
Cable entry method
CT requirements
210 Technical specifications  Manual Power Quality Filter PQFS
Table 63: Technical Specifications
Nominal output at 0 to 1000m (3300ft) above sea level (for
derating refer to
-10°C (23°F) non condensing
40°C (104°F) (for derating refer to
35°C (95°F)
Max. 95% non-condensing during operation.
Max. 85% non-condensing during storage.
Chemical class 3C2 (for more information refer to
14)
Mechanical class 3S2 (for more information refer to
14)
Max. 0.3mm (2-9Hz)
2
Max. 1m/s (9-200Hz)
Max. 40m/s² - 22ms
IP30
W x D x H: 588 x 326 x 752 mm
W x D x H: 588 x 326 x 795 mm (including fixations)
130 kgs
RAL 7035 (light gray)
Wall mounted (fixation plates included)
Bottom cable entry
3 CTs are required (Class 1.0 or better)
Filter burden: 5 VA for upto 4 units
15 VA burden for up to 30 m of 2.5 mm² cable
Table 14)
Table 14)
Table
Table