Carbon Canister Removal (continued)
Carbon Canister Test
Carbon Canister Inspection
Fuel System: Service and Repairs
4. Remove the manifold vent hose from the intake manifold. Remove the
carbon canister from the engine.
1. Connect a hand vacuum pump to the hose attached to the "V" port on the
carbon canister.
2. Place a thumb over the hose attached to the "P" port on the carbon canister.
3. Apply a vacuum with the hand pump. If the vacuum builds at the vacuum
pump gauge, replace the carbon canister assembly.
The fittings on the carbon canister are marked. The "T" is the longer hose leading
to the fuel tank fitting. The "P" is the shorter hose leading to intake manifold.
Figure 57
Figure 58
Page 6–6
1P65F-2 Service Manual
3429-270 Rev A