EN
11.2.1. Password
Home
Settings
Password-setting
11.2.2. Sensor settings
Important:
Sensors from BEKO TECHNOLOGIES with SDI signal such as DP109 and FS109/211 are generally pre-configured and can be
connected without further adjustments to a free sensor channel!
For instructions regarding the configuration of RS485/Modbus sensors (SD23, etc.) see „11.2.2.10. Type "Modbus"" page
61.
Settings
Home
Sensor-settings
METPOINT
BDL compact
®
Installation and operating manual
Default password (factory settings): 4321
If required, change the password under
Password-setting
Enter the new password twice and confirm with OK.
If the two password entries do not match, message
Enter password
or
Confirm new password
displayed in red.
If you have forgotten your password, enter the
master password and then a new password.
The master password can be requested from
BEKO TECHNOLOGIES GmbH, with the serial
number of the METPOINT
the request.
Enter the password. An overview of the available
channels is displayed.
Depending on your device mode, there are 2 or 4
channels.
Note:
Normally, no channels are preset!
is
BDL compact specified in
®
45