Type "Modbus - Beko METPOINT BDL compact Installation And Operating Manual

EN

11.2.2.10. Type "Modbus"

11.2.2.10.1. Selecting and activating sensor type
Step 1: select a free sensor channel
Home  Settings Sensor
Step 2: select Modbus type
Home  Settings  Sensor-settings
Step 3: confirm with OK
Enter a name (see chapter 11.2.2.7 "Labelling and configuring text fields").
Home  Settings  Sensor-settings  A1  right arrow (2. page)  VA  use
11.2.2.10.2. General Modbus settings
 Settings Sensor-settings A1
Home
METPOINT BDL compact
®
settings A1
 A1  Type 
right arrow (2. page)  Modbus settings
Modbus
Via Modbus, up to 8 register values (from the input
or holding registers) of the sensor can be read out.
Select one or more registers
by checking the
Enter the Modbus
1 – 247. (e.g.
Enter all serial transmission settings such as
rate, stop bit,
If the METPOINT
the bus terminal, press the Term button to activate
termination. You also have the option to press the
Bias button to use a BIAS.
Confirm the changes with OK.
To reset the values to the default settings, press the
Default values
The Modbus ID
specified in the sensor data sheet.
Installation and operating manual
(Va –Vh ) and activate
use box.

ID
ID of the sensor; available values:
Modbus ID = 12)
parity bit and timeout.
BDL compact is connected to
®
button.
and the transmission settings are
baud
61