Configuring Analog Sensors - Beko METPOINT BDL compact Installation And Operating Manual

Installation and operating manual

11.2.2.8. Configuring analog sensors

Only possible with METPOINT
Overview of the possible Type
For BEKO-Digital see chapter 11.2.2.8.1 Selecting sensor type (example: BEKO Digital sensor) and chapter 11.2.2.1 BEKO
Digital dew point sensor
The Alarm and Record buttons, the
in chapter 11.2.2 Sensor settings.
For the labelling of the text fields, see chapter 11.2.2.7 Labelling and configuring text fields!
11.2.2.8.1. Type 0/4 – 20 mA / Type 0 – 1/10/30 V
Home  Settings  Sensor-settings
Home  Settings Sensor
56
BDL compact models with fully equipped analog board.
®
settings, including examples.
Resolution for digital places as well as the
 B1  Type 
settings B1 right arrow (2. page)
Short name
4 - 20 mA
For details regarding the scaling of the sensor (here:
type 4 – 20
to the data sheet of the sensor.
e.g. SP21
In Scal. 4 mA, enter the lower scale limit. In
Scal. 20 mA, enter the upper scale limit.
The Ext. sensor supply voltage
the sensor requires it.
Press the Set value to (offset)
measured data from the sensor to a certain value
(offset).
The positive or negative difference of the Offset
displayed.
Press the Reset
and the Value name
mA, corresponding to 0 – 25 bar), refer
is switched on when
button to set the
button, to reset the Offset
METPOINT
EN
are described
is
to zero.
BDL compact
®