Removal Of The Float Switch; Removal Of The Thermistors From The Liquid And Gas Pipes - Hitachi RCI Service Manual

10 Servicing

10.1.10 Removal of the float switch

Nº
1 Securing plate screw
2 Securing base
3 Drain mechanism
4 Float switch
5 Nut
Remove the drain pan Removal of the drain
273.
Loosen the resin nut securing the float switch and remove it.
Remove the two screws securing the drain mechanism to remove
the mechanism.

10.1.11 Removal of the thermistors from the liquid and gas pipes

Nº
1 Thermistor securing plate
2 Thermistor
Remove the optional air panel in line with the instructions given in
chapter Removal of the optional air
Remove the fan duct in line with the instructions given in chapter
Bellmouth removal, see on page 271.
Remove the drain pan as indicated in chapter
pan, see on page 273.
Remove the butyl sheet covering the thermistor. Remove the plate
securing the thermistor to the pipe on which it is located and
remove.
N O T E
The thermistor protection and securing system is the same on
the gas and liquid pipe.
274
SMGB0063 rev. 1 - 10/2010
Part
pan, see on page
Part
panel, see on page 270.
Removal of the drain