Econofresh Kit; Accessories Supplied With The Unit; Unit Installation - Hitachi RCI Service Manual

2 Unit installation

2.10 Econofresh Kit

2.10.1 Accessories supplied with the unit

Check that the following accessories are supplied with the unit.
N O T E
Please contact your HITACHI distributor if any of the accessories has not been supplied with the unit.
Accessory
AS cable
Outdoor thermistor (8 mm)
Screw (for connecting RPI
and Econofresh hoses)

2.10.2 Unit installation

Initial checks
See the indoor unit installation and operation manual before installing the Econofresh kit.
1. Air flow direction.
Before starting installation, plan the direction of the pipes and wiring
required. Also bear in mind that there must be enough space
around the unit for installation and maintenance.
Check that the ceiling surface where the unit is to be installed is
completely horizontal.
Installation
Avoid obstacles that could block the air inlet or outlet flow.
Prepare the sling bolts.
Thread on the nuts and fit the washers for all the bolts, as shown in the figure.
Fit two suspension brackets onto the nut and washer of each bolt, starting on one side.
66
SMGB0063 rev. 1 - 10/2010
Appearance
Image not available
Image not available
Image not available
Quantity Purpose
1
1
12
–
–
–