GE LOGIQ E9 Service Manual page 508

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Options Holder / Left or Right Support replacement

The Options Holder (the Left Support or Right Support) is the base piece that attaches to the upper

console to support either a Transvaginal Probe Holder, a Gel Warmer, or a Storage Tray. The system

can support one Left Options Holder and one Right Options Holder at the same time. A Right Options

Holder comes standard with the system, with the Gel Warmer (48V).

One person, 15 minutes.

For tools needed, refer to:

Preparations

When preparing for the replacement, you must perform the following steps:

Energy Control and Power Lockout for LOGIQ E9

WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO VOLTAGE

GREATER THAN 30 VOLTS:

1. TURN OFF THE SCANNER.

2. UNPLUG THE SYSTEM.

3. MAINTAIN CONTROL OF THE SYSTEM POWER PLUG.

4. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE AS THERE ARE NO

TEST POINTS TO VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON

WILL TURN OFF.

5. DISCONNECT THE EPS (EXTENDED POWER SHUTDOWN) BATTERY AT J3, OR THE

BATTERY FROM THE CHARGEBOARD AT PCN1 WHEN WORKING IN THE BEP. THIS SHOULD

BE DONE WHENEVER THE BEP IS OPEN AND THE EPS OR CHARGEBOARD IS EXPOSED AND

CHANGING PARTS.

Beware that the Main Power Supply, Extended Power Shutdown or ChargeBoard and BEP may be

energized even if the power is turned OFF if the cord is still plugged into the AC Outlet.

1.) Power down the system.

2.) Disconnect the mains power cable from the wall outlet.

3.) If the Options Holder is supporting the Gel Warmer, remove the Gel Warmer first

Warmer replacement" on page

4.) Separate and remove the Storage Tray or Transvaginal Probe Holder from the Options Holder, if

Follow these links if you need more information:

4-2-3 "Power shut down" on page 4-7.

8-6-12 "Gel Warmer replacement" on page 8-166.

8-6-13 "Storage Tray / Transvaginal Probe Holder replacement" on page 8-170.

8-2-5 "Tools needed for servicing the LOGIQ E9" on page

Section 8-6 - Replacing Top Console Parts

(8-6-12 "Gel