Lenovo Moto Z4 Service And Repair Manual page 166

Lenovo Moto Z4
Level 2 – Service and Repair Manual
6. U se cotton swabs and ISP Alcohol to
4 2 7 B
clean the Display bonding ledge on the
Display. The Display bonding ledge is
highlighted in the photo.
/ / CAUTION //
1 6 2 3 B
Display bonding ledge cleaning is critical to the
phone's water resistance. You must thoroughly
clean the surface with ISP Alcohol and allow it
to dry completely before applying 3M AP-111
Adhesion Promoter.
7. W ait for the ISP Alcohol to dry
4 2 8 B
completely.
/ / CAUTION //
1 6 2 4 B
D o not use the same cotton swabs to clean
1 5 4 7 B
with ISP Alcohol and apply 3M AP-111
Adhesion Promoter. The Display will not
properly adhere to the Rear Housing if the
cotton swabs are reused. The cotton swabs
may be used for 2 applications of the same
chemical, but then must be discarded.
8. Repeat steps 1-2 one time.
9. U se clean cotton swabs to apply 3M AP-
4 3 0 B
111 Adhesion Promoter to the Display
bonding ledge.
10. Wait for the 3M AP-111 Adhesion
Promoter to dry.
11. Peel the protective carrier from the
Display Adhesive.
12. Place the Display Adhesive into the
Display Press Fixture (3-00-W8-10000)
sticky side up as shown.
PAGE 166
Lenovo Confidential Restricted:
Do not share without consent from Lenovo