GE LOGIQ E9 Service Manual page 47

GE H
EALTHCARE
D 5180263-100, R
IRECTION
Table 1-6
5
EV
Product icons (Continued) 4 of 6
LABEL/SYMBOL
or
Chapter 1 Introduction
PURPOSE/MEANING
"Mains ON"
Indicates the Power ON position of the
mains power switch.
"ON" Indicates the power on position of
the power switch.
CAUTION
THE ON/OFF BUTTON ON
THE OPERATOR PANEL
DOES NOT ISOLATE MAINS
SUPPLY
ON/OFF button
CAUTION
SYSTEM SHUTDOWN USING
THE ON/OFF BUTTON DOES
NOT DISCONNECT LOGIQ E9
FROM MAINS VOLTAGE.
For disconnecting LOGIQ E9 from
mains voltage after system shutdown,
please set the circuit breaker close to
the mains inlet to OFF as described in
4-2-4 "Power shut down" on page
"Protective Earth"
Indicates the protective earth
(grounding) terminal.
"Equipotential"
Indicates the terminal to be used for
connecting equipotential conductors
when interconnecting (grounding) with
other equipment as described in
IEC60601-1.
Alternating Current symbol is in
accordance with IEC 60878-01-14.
This symbol indicates that waste
electrical and electronic equipment
must not be disposed of as unsorted
municipal waste and must be collected
separately. Please contact an
authorized representative of the
manufacturer for information concerning
the decommissioning of your
equipment.
LOGIQ E9 Service Manual
LOCATION
Rear of console
Operating Panel
4-7.
Used several places inside the system.
Rear of console
Rear Panel, Rating Plate, Circuit
breaker label of console and Front
Panel (if applicable).
Rear of console
Rear of LCD Monitor (inside)
1 - 13