GE LOGIQ E9 Service Manual page 497

GE H
EALTHCARE
D 5180263-100, R
IRECTION
Table 8-55
4.
Remove the two 5 mm HEX key screws at
the inside base of the BEP.
5. Reach inside the BEP to disconnect the
BEP to Backplane cable from J3 on a GFI
Configuration.
Release the lock connector for the BEP to
Backplane cable, J2 (left) on a MRX
Configuration. Keep the cable to transfer to
the replacement BEP.
6.
Slide:
• the entire BEP away from the system approximately one inch, then finish removing the printer
bracket.
• the entire BEP out of chassis and remove the BEP from the system.
5
EV
BEP removal - R3.x and earlier
Steps
Chapter 8 Replacement procedures
Corresponding Graphic
BEP Base HEX key screws
BEP Cable to Backplane J3 of GFI Configuration
(views inside the BEP)
BEP Cable to Backplane, J2 (left) of
MRX Configuration
LOGIQ E9 Service Manual
8 - 133