GE LOGIQ E9 Service Manual page 577

GE H
EALTHCARE
D 5180263-100, R
IRECTION
8-12-2 Assembling or replacing the Roll Stand (cont'd)
5.) Loosen the knob slightly, guide the arm into the channel and move it to the mounting position.
NOTE: Make sure the Transformer Support Platform (larger view) in
page 8-213
NOTE: The channel fits between the front and rear slide plates.
5
EV
Figure 8-64 Loosening Knob
is installed in the UP position.
Figure 8-65 Channel Location
Chapter 8 Replacement procedures
LOGIQ E9 Service Manual
Figure 8-64 "Loosening Knob" on
8 - 213