Symbols Used - Bosch Rexroth BS 2/C Series Assembly Instructions Manual

18/76 Assembly
Table 6: Symbols used
1 2
SW13
M = 20Nm
D
SW5
M = 8Nm
D
PZ2 PH3
gleitmo 585 K Anti-Seize
Loctite 243 Loctite 601
1 2 3
A B C X
Bosch Rexroth AG, MIT: BS 2/C-... + BS 2/R-..., 3 842 358 724/2013-04

7.5 Symbols used

Connect with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting and tightening
in the slot. The notch at the end of the bolt indicates the T-bolt orientation.
1 = T-bolt insertion orientation in the slot.
2 = T-bolt clamping position in the slot.
Maximum tightening torque: 25 Nm.
Wrench for hexagonal screw
SW = wrench size (WS) ... mm
M = required tightening torque ... Nm
D
Wrench for hex-socket screw
SW = wrench size (WS) ... mm
M = required tightening torque ... Nm
D
Screwdriver for recessed head screws
PZ ... = Pozidriv recessed head, size ...
PH ... = Phillips recessed head, size ...
Lubricate with Structovis GHD, 0 842 904 229.
Grease/grease with specifi ed lubricant:
• gleitmo 585 K: gleitmo 585 K, www.fuchs-lubritech.com
• Anti-Seize: Food Grade Anti-Seize/Loctite 8014, www.henkel.com
Secure the screws with:
• Loctite 243: medium strength adhesive (detachable), www.loctite.de
• Loctite 601: high strength adhesive (permanent), www.loctite.de
The identifi ed parts are not required for the assembly situation described.
Use the parts in another application or dispose of them.
Sequence of assembly steps in the graphics.
The numbers correspond with the order of the assembly steps according
to the instructions in the accompanying text.
Designation of components in graphics.
The letters identify the components specifi ed in the instructions.