Paper Handling - Brother HL-2600CN Series User Manual

CHAPTER 6 TROUBLE SHOOTING
P H
P H
P H
A P E R A N
A P E R A N
A P E R A N
Question
The printer does not
load paper.
How can I load
envelopes?
Which paper can I
use?
How can I clear paper
jams?
The printer feeds more
than one sheet at a
time.
Paper skews while
feeding.
Sometimes mis-picking
of paper from the
paper tray or mis-
feeding of paper from
the paper exit occurs.
D L I N G
D L I N G
D L I N G
Recommendation
Check to see if the Alarm LED is on. If so, the
•
Paper Cassette may be out of paper or not
properly installed. If it is empty, load a new stack
of paper into the Paper Cassette.
If there is paper in the Paper Cassette, make sure
•
that it is straight. If the paper is curled, you should
straighten it before printing. Sometimes it is helpful
to remove the paper, turn the stack over, and then
reload it in the paper tray.
Reduce the stack of paper in the Paper Cassette,
•
and then try again.
You can load envelopes from the Paper Cassette
(Tray 1). Make sure you adjust the paper guide. Your
application software also must be set up correctly to
print on the envelope size you are using. This is
usually done in the page setup or document setup
menu of your software. Refer to your applications
manual for more information.
See 'Paper Handling' in Chapter 3 for detailed paper
specifications.
See the "Paper Jams" section in this chapter.
Check to verify the following:
The paper loaded is all the same type.
•
Paper that meets the specifications is loaded.
•
Paper stack was fanned before loading.
•
The stack of paper is not too high.
•
The side guide is not set too tight.
•
Check to verify the following:
The side guide is adjusted correctly.
•
The amount of paper you loaded is correct. Refer
•
to the 'PAPER SPECIFICATIONS' section in
APPENDICES.
Clean the Paper Guide, the Registration Roller and the
Exit Roller referring to 'Periodical Printer Cleaning' in
Chapter 5.
6-20