Figure 4-26 Console Configuration - Ethernet Ports - Siemens A80672 Installation & Operation Manual

_______________________________________________________________________________________________________________
Figure 4-26 displays the Ethernet Port configuration screen. Four tabs select the sub-menus. Port 1 through
Port 3 are located on the bottom of the console. The DNS tab is used to set the DNS server IP Addresses.
Port 1-3 Configuration - Disabled
•
The ETH1 through ETH3 Ethernet ports have the same configuration options which includes DHCP options
(Disabled and Client), IP Address, Network Mask, Default Gateway, Path Type, Recovery Time, Test Period,
Fail Count, Op Traffic Only, RSSI Value, and Protocol settings. No current applications use Office or Field Path
types and should be configured with the default (NONE) path type.
ETH1, ETH2, ETH3 Port Configuration - Client
•
The ETH1 through ETH3 Ethernet ports have the same configuration options which includes DHCP options
(Client, and Disabled), Path Type, Recovery Time, Test Period, Fail Count, Op Traffic Only, RSSI Value, and
Protocol settings. No current applications use Office or Field Path types should be configured with the default
("None") Path Type.
SIG-00-13-12
Version No.: B

Figure 4-26 Console Configuration - Ethernet Ports

Protocol and Path Type should always be set to None.
NOTE
4-17
WEB USER INTERFACE (WEBUI)
February 2021