Epson Stylus PHOTO RX640 Service Manual page 49

EPSON Stylus PHOTO RX640/650
Check the following before installing the Middle Housing:
• Stacker operates properly.
• The harness is routed properly. (Fig. 4-21), (Fig. 4-22)
When installing the Middle Housing, check the following:
• Printhead FFCs (x2) are lead out properly. (Fig. 4-23)
• Ground Plate is located in front of printer frame. (Fig. 4-23)
• The left and right bottom areas of the Front Housing are
engaged with the projections of Bottom Housing.
• The screws are tightened in the order specified.
(éüÇÃÉyÅ[ÉWÇ÷ë±Ç¦)
~Rear right~ ~Rear left~
After setting the
ferrite cores in place,
stick the acetate tape.
~Left side~
Figure 4-21. Routing the Harness 1
Disassembly and Assembly
(p.55)
(Fig. 4-24)
(Fig. 4-20)
Hooks
Removal of Exterior Parts
Figure 4-22. Routing the Harness 2
~Front side~
Ground Plate
~Rear side~
Figure 4-23. Routing the Printhead FFC
Revision A
Acetate Tape 18x20 (x6)
Acetate Tape 18x20
Hooks
Printhead FFC
Locate the tip of Ground
Plate on the front side
49