Waste Ink Tray Assy - Epson Stylus PHOTO RX640 Service Manual

EPSON Stylus PHOTO RX640/650
After installing the Middle Housing, check the following
conditions:
• Waste Ink Tube is routed properly. (Fig. 4-24)

4.2.6 Waste Ink Tray Assy

C A U T I O N
When removing the Waste Ink Tray Assy, take due care not to
stain any surrounding objects with waste ink.
1. Remove the Panel Assy (p.43)
2. Remove the Scanner Unit. (p. 45)
3. Remove the Middle Housing (p.48)
4. Remove the Waste Ink Tube from the Waste Ink Tray Assy. (Fig. 4-25)
When connecting the Waste Ink Tube, wipe the ink, if any, off
the joint area of the tube. With ink left adhering to the joint
area, the tube cannot be connected firmly and thus may easily
come off.
Route the Waste Ink Tube along the hooks of the Housing
Lower Assy, and take care that the tube is not flattened with
the Waste Ink Tray. (Fig. 4-24)
A D J U S T M E N T
On the occasion of replacing a part with a new one, replace all the
R E Q U I R E D
specified parts with new ones and clear the counter value after
assembly.
5.1.1 Adjustment by Use of Adjustment Program (TBD) (p.72)
Disassembly and Assembly
Figure 4-24. Checking the installation of the Middle Housing
Figure 4-25. Removing the Waste Ink Tray Assy
Removal of Exterior Parts
Projection Groove for Waste Ink Tube
Projection
Hook
Waste Ink Tray Assy
Waste Ink Tube (to the I/S Assy)
Revision A
Hook
50