Home Position Adjustment Procedure - Epson Stylus PHOTO RX640 Service Manual

EPSON Stylus PHOTO RX640/650

5.1.5 Home Position Adjustment Procedure

1. Connect the Stylus PHOTO RX640/650 to the PC with the USB cable, turn the power
on, and set the home position adjustment tool.
C H E C K
Place the home position adjustment tool in close contact with
P O I N T
the upper left corner of the document table. Leave the top cover
of the scanner open.
A new registry is created on the PC every time this adjustment
is repeated and if the number of the registries exceeds a certain
level, the program will go into an error. In such a case, check
the check box for Delete Registry to erase the registries.
2. Run the adjustment program. Upon start, the "Select Parameter Set" window will
open. (See Figure 5-5)
Select "Yebisu" and click [OK].
3. When the window shown in the figure is displayed, click the "SEQ" icon on the
toolbar. (See Figure 5-6)
4. When the window shown in the figure is displayed, click the [Execute] button to
run the program. (See Figure 5-7)
5. On completion of writing, the check screen appears. Confirm that "TEST OK" is
displayed on the top line. If "TEST OK" is not displayed, make the adjustment
again.
Adjustment
In close contact
with the upper
left corner
Home position
adjustment tool
Overview
Figure 5-5. Parameter Setting
"SEQ" icon
Figure 5-6. Single Test Dialog Display
Figure 5-7. Execution of Home Position Adjustment
"TEST OK"
Figure 5-8. OK Screen
Revision B
Revision B
Select the model name (Yebisu)
and click the [OK] button
[Execute] button
76