Joystick Raise And Lower/Mow Switches; Front Reels Down Sensor - Toro Reelmaster 5200-D Service Manual

Joystick Raise and Lower/Mow Switches

Two micro switches for the joy stick are located on the
lift control mechanism that is inside the control console.
The rear switch on the mechanism is used to lower the
reels and the front switch to raise them. A normally open
contact closes when the joy stick is positioned to either
to lower or raise the reels. Each switch has a electrical
connector to make sure the normally closed contact on
the switch is not used. The raise switch has violet and
black wires connected to it and the lower switch has pink
and black wires.

Front Reels Down Sensor

The sensor consists of two parts. The reed switch is lo-
cated on the left end of the carrier frame and has a nor-
mally open contact. The switch actuator is located on the
left lift arm and is made of a magnetic material. When the
front reels are lowered, the magnetic field of the actuator
is positioned near the reed switch, and the contact in the
switch closes. The switch has a electrical connector at-
tached to the carrier frame.
Reelmaster 5200-D/5400-D
2
Unit Serial No.
80001-209999999
1. Joy stick
2. Micro switch
3
1
1. Reed switch
2. Switch actuator
Page 5 - 31
1
3
2
Unit Serial No.
210000001 & Up
Figure 47
3. Lift control mechanism
2
4
Figure 48
3. Carrier frame
4. Lift arm (LH)
Electrical Systems