Adjust Cutoff Bar; Adjust Lock-Up Roller - Toro Reelmaster 5200-D Service Manual

Adjust Cutoff Bar

Adjust top bar to make sure clippings are cleanly dis-
charged from reel area:
NOTE: Bar should be parallel to reel for optimum per-
formance and should be adjusted whenever shield
height is adjusted or whenever reel is sharpened on a
reel grinder.
1. Loosen screws securing top bar. Insert 0.060 inch
(1.52 mm) feeler gauge between the top of the reel and
bar; tighten screws. Make sure bar and reel are an equal
distance apart across the entire reel.
2. Do adjustment on remaining cutting units.

Adjust Lock-up Roller

Adjust lock-up rollers so they contact the lock-up lever
on each rear lift arm and support the cutting units when
fully raised. The cutting units should have approximately
3/8 to 5/8 inch (9.5 to 15.9 mm) vertical travel when mea-
sured at the rear roller.
Cutting Units
(Model 03506, S/N 80001 - 209999999)
(Model 03509, S/N 80001 - 209999999)
1
1. Cutoff bar
1
1. Lock-up roller
Page 8 - 12
Rev. A
2
Figure 15
2. Mounting screw
2
Figure 16
2. Lock-up lever
Reelmaster 5200-D/5400-D