Toro Reelmaster 5200-D Service Manual page 181

5. Install the correct bearing shims and a new inner
bearing cup using a press plate of proper diameter.
Push the bearing into the housing until it bottoms out
against the shims (Fig. 41).
Note: Pinion bearing shims are available in 0.003 in.
(0.08 mm), 0.005 in. (0.13 mm), 0.010 in. (0.25 mm),
and 0.030 in. (0.76 mm) thickness.
6. Insert the spur gear into the front housing with the
chamfered area of the center spline toward the pinion
gear. Tap the pinion gear with a soft mallet to engage the
splines in the spur gear (Fig. 42).
7. Support the drive pinion in a suitable press (Fig. 43).
Reelmaster 5200-D/5400-D Page 6 - 19
Rev. A
Figure 41
Figure 42
Figure 43
Differential Axle