Table of Contents
Advertisement
14.3 Registering the Lossnay Unit with the Lossnay
M-NET Remote Controller
Initial registration mode operation
A Lossnay unit must be registered with the Lossnay M-NET remote controller in a group arrangement. Register a Lossnay unit
using the initial registration mode as shown below. In addition, the initial registration mode can be used to search for a Lossnay
unit registered to the group or to delete a registration.
Setting Procedure
1 Turn off the unit.
(Perform the following operation after "HO" flashes on the display.)
2 Hold down both
This starts the initial registration mode and the set Lossnay M-NET remote controller address flashes on the display.
3 Press
to select the address of the Lossnay unit that you wish to register with this Lossnay M-NET remote controller.
After the button is pressed once, the Lossnay M-NET remote controller address and then the Lossnay unit address is dis-
played. Afterwards, each press of the button increase the Lossnay unit address by 1 as shown below. Holding down the but-
ton changes the address more quickly.
( Set Lossnay M-NET remote controller address )
4 When the address of the Lossnay unit that you wish to register is displayed, press
If the registration is completed correctly, the display appears as shown below.
If the registration is not completed correctly, "
the wiring are correct.
In the case of LGH-200RX type, there are 2 circuit boards installed in each unit. Because of this, set a separate address for
each of the circuit boards, and register both of those addresses at the remote control.
5 After registering, hold down both
mal display appears.
3
2
5
and
for more than 2 seconds.
FILTER
[ 101 ]
Flashes
and
FILTER
CENTRAL
INTERLOCKED
HEAT EX.
BY-PASS
AUTO
CHECK
NOT AVAILABLE FILTER
ON/OFF
FILTER
[ – – – ]
[ 001 ]
[ 002 ]
The Lossnay unit type,
"LC", is displayed.
" flashes in the display. Check that the selected Lossnay unit address and
for more than 2 seconds to end the initial registration mode and the nor-
17
4
6
. . .
[ 098 ]
[ 099 ]
to begin registering.
179
Advertisement
Table of Contents
