Mitsubishi Electric Lossnay LGH-100RX3-CAN Technical Manual page 189

15.1.4 Interlocked operation setting
This is the procedure for registering the interlocked operation of an Lossnay unit with a single or multiple indoor units.
All indoor units to be interlocked with an Lossnay unit for operation should be registered as group before- hand.
Example of an interlocked group configuration
051
MENU
1 OPERATION MONITOR
2 OPERATION SETTING
3 SCHEDULE SETTING
4 MALFUNCTION
MONITOR
5 CURRENT TIME
SETTING
MENU
1 GROUP SETTING
2 INTERLOCKED
SETTING
3 REFRIGERANT
MONITOR
4 MALFUNCTION LOG
MONITOR
5 USER SETTING
INTERLOCKED SETTING
INTERLOCKED
UNIT ADDRESS
UNIT ADDRESS
186
001 002 003
101 103
1 Set DIP switch No. 1 in the cover to ON.
WED 15:29
Note:
Always uses the DIP switch No. 1 to change the setting.
This operation will be invalid if performed on another screen.
2 The initial menu screen is displayed.
3 Press the
4 The interlocked setting screen is displayed.
The minimum address of the interlocked processing unit that can be set to
interlocked operation with an indoor unit is displayed in "INTERLOCKED UNIT
005
ADDRESS". The cursor is displayed in the unit address display position.
5 Press the
Lossnay unit that the setting will be performed on.
Duct
004 005
2
button to select "2 INTERLOCKED SETTING".
GROUP
button to display the address number of the interlocked
SELECT
Outdoor unit
Indoor unit
Local remote controller
Lossnay unit
M-NET Transmission cable