15.3 Network Remote Controller (PAR-F27MEA)
15.3.1 Method for Operating Lossnay with Network remote
Controller (When Interlocked with City Multi Indoor Unit)
Operation method is same as A-control remote controller. Refer to page 190.
15.3.2 Initial registration mode
This is the procedure for registering the address of the indoor unit with the remote controller.
1 Stop the remote controller by pressing the [ON/OFF] button.
•
If not indoor unit is registered, the "HO" display appears in the room temperature display. In this condition, registration
can be performed as follows.
2 Display "INDOOR UNIT ADDRESS NO."
Press and hold down both the [FILTER] button (shown as A) and the "Louver" button (shown as B) at the same time for
•
2 seconds. The following display will appear.
15.3.3 Interlocked registration
3 Display the "OA UNIT ADDRESS NO."
Press the "Operation mode" button (shown as G) and the following display will appear.
•
Press once again to return to "INDOOR UNIT ADDRESS NO." shown in Step 2.
INDOOR UNIT
ADDRESS NO.
•
Use the
and
Set it to the address of the indoor unit to be interlocked.
•
Use the
and
tered.
CENTRALLY CONTROLLED
AUTO OFF
STAND BY
DEFROST
C
G
PAR-F27MEA
E
INDOOR UNIT
ADDRESS NO.
OA UNIT ADDRESS NO.
[TEMP] buttons (shown as C) to select the address of the indoor unit.
[TIMER SET] buttons (shown as H) to select the address of the Lossnay unit to be regis-
INDOOR UNIT
ADDRESS NO.
F
1Hr.
DAILY
ON OFF
CLOCK
REMAINDER
FILTER
CHECK MODE
TEST RUN
LIMIT TEMP.
ERROR CODE
NOT AVAILABLE
TEMP.
ON/OFF
CLOCK→ON→OFF
FILTER
CHECK TEST
TIMER SET
H
B
D
Both "INDOOR UNIT ADDRESS NO." and "OA
UNIT ADDRESS NO." will appear simultaneously.
OA UNIT ADDRESS NO.
A
191