Mitsubishi Electric Lossnay LGH-100RX3-CAN Technical Manual page 187

15.1.3 Group configuration setting
Registration can be made for the indoor units, local remote controllers and slave system controllers in the same group.
Registration can also be performed for the group that is composed of only Lossnay.
Example of a group configuration
Supply the power from the power supply unit (PAC-SC34KUA) through the M-NET transmission cable.
051
001
Air conditioner group
Perform the following procedures to set the group configuration because the interlocked operation setting will not be per-
formed for the group configuration settings that have not been set.
MENU
1 GROUP SETTING
GROUP SETTING
G01
ADDRESS
UNIT
REMOTE CONTROLLER
SYSTEM CONTROLLER
GROUP SETTING
G01
ADDRESS
UNIT
001 002
REMOTE CONTROLLER
101
SYSTEM CONTROLLER
Note:
Do not set Lossnay units with the intention of interlocked operation, such as Lossnay, on this group setting menu.
Even if the addresses are input in a non-sequential order, they will be switched to sequential order starting with the lowest
address.
The independent Lossnay unit cannot be set to the indoor unit group and it cannot be set as an interlocked Lossnay unit.
184
002 003
101 103
Group 1 Group 2
Independent Lossnay group
1 When the power is supplied to the controller, the screen shown on the left is
displayed.
2 Press the
The configuration setting screen is displayed.
3 Press the
4 Press the
display position to be set.
5 Use the numeric keypad to set the address of the indoor unit, local remote
controller, and slave system controller in the display group number.
Operation example
For an indoor unit with an address of 012.
1) Input "0"
2) Input "1"
3) Input "2"
4) Press the
* It is also possible to enter "1" "2".
When the input is incorrect
Press the
RESET
DEL.
005 006
004
105
Group 3
1
button to select "1 GROUP SETTING".
GROUP
button to display the group number to be set.
SELECT
0
01
012
button.
button and continue to input the data. After pressing the
button, move the cursor to the addresses to be deleted and press the
button to delete these addresses.
Outdoor unit
Indoor unit
Local remote controller
Lossnay unit
M-NET Transmission cable
button to move the cursor to the address
012